![]() In the Extrusion dialog window, there is a section for the degree of taper angle. If you don't have a particular second diameter in mind (or if you don't want to do trigonometry), you can add a taper angle to the extrusion of the first circle.Lastly, start the Loft command (Create -> Loft), and select the two circular profiles. To ensure this, you can project (Sketch -> Project/Intersect -> Project) the first circle into the second sketch for reference. Then, create a sketch on this new construction plane, and sketch the second circle directly above the first one. ![]() Next, create an Offset Plane (Construct -> Offset Plane) off of the original sketch plane. The G0 (Connected), G1 (Tangent) and G2 (Curvature) options are available when the loft profile is the edge or face of a body (see: Loft Dialog Box). Beforehand, G0, G1 and G2 continuity options were available. Create the first sketch with the first diameter as you normally would. When recreating a 'Loft' feature between faces of two bodies in Fusion 360, it is only possible to select 'Connected' and 'Direction' as end conditions. ![]() Take advantage of the Loft command! The loft command is built exactly for this: creating a transitional shape. Make a new sketch on each surface that you are trying to loft, sketching 2 circles that match those existing body edges.An operation that removes material from a feature and creates a hollow. occur in features like Shell, Fillet, Face Draft, Loft, and other complex modeling features. Creates a 3D solid or surface by specifying a series of cross sections. ![]() There are many ways to do this, but here are the easiest two: Fusion 360 Shell Tool Tutorial Creating Hollow Objects. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |